Common Failures

Common Failures & Solutions

Failures	Solutions
No Image(Black Screen)	Please confirm whether video source is well connected to HDMI output connector of receiver; Please confirm whether receiver is powered on normally; Please confirm whether monitor is working properly;
Shown "Searching TX"	Please check whether transmitter is powered on normally; The signal is weak at receiver side. It's recommended to reduce the transmission distance appropriately; Please power off and reboot or re-pair;
Shown "No Signal Input"	Please check whether the signal source of HDMI is normal; Please confirm whether the output resolution of the signal source is within the supported range; Please confirm whether the signal source is connected to the HDMI input of the transmitter;
Short Transmission Distance	The signal is weak, please adjust the antenna angle or the device placement; Concrete walls, brick walls, wallpaper, metal doors, bullet-proof glass, etc. have a relatively large attenuation of RF signals. Please avoid such obstacles as much as possible in the straight transmission path; Caused by co-channel interference. Please adjust the channel to avoid interference frequency;
Image Lagged	The signal is weak, please adjust the antenna angle or the device placement; Caused by co-channel interference. Please adjust the channel to avoid interference frequency; The equipment is too far away. It's recommended to reduce the transmission distance appropriately;
Infrared Return Invalid	Please confirm whether the infrared transmitter or receiver is inserted into the wrong hole; The infrared transmitter should be placed in front of the receiving range of the receiving device as much as possible;
Loopout Failure	Please confirm whether HDMI cable is well connected to HDMI output connector of transmitter; If not, please plug it in and out again;