Interfaces
Last updated
Last updated
RJ45 Jack: LAN0
RJ45 Jack: LAN1
DC Jack: DC7V~35V wide voltage, DC12V is better and recommended.
3G/4G/WIFI Antenna: SMA external rotation internal hole interface.
RESET: press for >5s when it’s powered on, SYS indicator will flash quickly and it’ll reboot. Then all settings will be reset to the default factory settings.
Serial Port: 4PIN PH2.0mm, GND/TX/RX/DC+ from left to right, DC+ can be used power supply to power on the router.
SIM card slot: Self-locking slot, press the white button on your left side and it will pop out.
From left to right: GND | TX | RX | DC+
Currently UART1 can only be used as RS232, it’s GND/TX/RX/DC+ from left to right. But for data transmission, only GND/TX/RX will be used, respectively connecting them to the 5PIN, 2PIN, 3PIN of computer’s serial port to establish serial communication. DC+ works as input and output connector of power supply. (E.g.: when input is 12V, then the output voltage is 12V too.)
There’re three SMA antenna ports, that is 3G/4G and 2x WiFi antenna ports. Users can select the appropriate antennas. Theoretically, the higher gain the antenna has, the better transmitting and receiving effect of WiFi it will be. For 3G/4G antenna, it’s recommended to use 3-5dB antenna. But for WiFi antenna, it depends on your requirement and coverage and supports max. 15dB.
Tips: 1) LAN0 can be used as WAN under regular router mode; 2) DC: 2.1mm Standard Round Interface, 7V~35V, Internal:+ (Positive), Outside: - (Negative).
Name
Status
Description
SYS
Indicator On
Powered and connected properly
SYS
Flash Quickly
Abnormal connection; 3G/4G Dialing;
Press "Reset" for >5s and it'll flash quickyly, then the router will reboot;
3G/4G
Green
Connected successfully, good signal
3G/4G
Red
Connected successfully, bad signal
3G/4G
Off
Failed to connect to 3G/4G module or abnormal
LAN0/1
On
RJ45 is connected
LAN0/1
Off
RJ45 is out of connection
